Building a Reaming and Inspection Station

Seth Baldasaro

Questions? Email Sonnax Tech Support about this article.

As valve bodies continue to evolve and become more complex, rebuilders are finding it increasingly necessary to have a central location for bench reaming and inspection of valve bodies. Many transmission shops have found – to their surprise – that building an inspection and reaming station can be inexpensive and that a station can be put together from many items already available in the shop.

The station may be as simple as an existing 20-gallon parts washer, submersible pump, flexible nozzle, filter and bench-mounted 360-degree swivel head vice (see Figures 1 and 2) and a Sonnax valve body reaming fixture (VB-FIX).

However, the station can be more elaborate and offer additional capabilities, such as vacuum testing, Wet Air Testing, hydraulic testing, valve body tool storage and surface finishing.

The foundation for a test and rebuild center that is more advanced than the one shown above is a sturdy bench with leg base plates to anchor it to the floor. An estimate for the size of the bench would be 3 feet by 4 feet, with a height of 3 feet.

Under the bench top, you’ll need to build a shelf for a 3- to 5-CFM vacuum pump. The vacuum pump will require a gauge and hoses, plumbed for easy access for circuit testing. The bench should also be pre-wired with a 4-plex outlet for vacuum pump and electrical accessories, such as Dremel tools. Plumb the bench for three lines of regulated air supply that can be quickly coupled to the main shop air.

Under the bench will live a drain shelf and tank for cutting fluid, to include a reaming fluid circulation pump. There should be a filter element to catch reaming chips before cutting fluid drains back to the tank. This filter and shelf can be as simple as an existing 20-gallon parts washer tank (with short legs) on 360-degree casters to roll under the bench when not reaming. A 5-foot hose from the cutting fluid pump will require a flex neck and spring clamps to allow multiple fixturing.

The Sonnax valve body fixture (VB-FIX) can be swivel-mounted onto the bench. There must be a pin with a length of at least 12 inches to allow an extension away from the bench for larger valve bodies. The valve body fixture, although designed to work with specific tools, may be used as a universal mount for all valve bodies: However it can have 1/4-inch holes added to both faces to fasten various valve bodies when non-guided reamers are used.

The bench top can also include a 3/4-inch by 12-inch by 12-inch marble or ground steel plate (flat to within .005”) for resurfacing pumps and valve bodies. (Resurface abrasive material is available from Goodson Tool Supply.) The plate requires a 2-inch slot or hub at the center for stator tubes in pumps. It has to be set on top of the bench to one side and sealed well enough to prevent cutting fluid from leaking into the tool drawer. The plate is for flat sanding pumps and valve bodies, and the slot allows a pump stator tube to pass through it.

On the top of the bench there should be edges approximately 2 inches high, turned up at 90 degrees and tapered approximately 1/2-inch away from operation to flow cutting oil away. A rear drain rail requires a drainback tube to the reservoir. The final additions to the bench include a drawer, which pulls out to one side for storage of tooling and reamers, an optional back with pegboard and an area for a shelf to set your three-ring binder, angled for ease of reading.

All the components to build a station may be readily found through Northern Hydraulics, McMaster Carr and Goodson Tools.

Seth Baldasaro is the director of strategic accounts.

Related Part(s)
Subject(s) Included
  • Valve Body Reaming

While Sonnax makes every effort to ensure the accuracy of technical articles at time of publication, we assume no liability for inaccuracies or for information which may become outdated or obsolete over time.

Was this helpful? No

Thanks for your feedback! Contact Sonnax tech support for assistance.

Thanks for your feedback!