Orifice Control Within the Converter, Part 1

Ed Lee

Questions? Email Sonnax Tech Support about this article.

Part One of a Three-Part Series

One of the more frequently asked torque converter questions is about the .028" orifice (Figure 1) found in some General Motors 298mm and 300mm TCC pistons with carbon weave lining.

Converter rebuilders want to know why some of the pistons have the orifice and some do not. The answer to this question begins with understanding why the orifice was used in the first place. The orifice was drilled through the piston to help cool the mass of the converter. The TCC release passage is open to exhaust when the converter is in the TCC apply mode. Metered oil, which is allowed to bypass the piston by way of the orifice, carries some heat away from the converter.



The Original Equipment Manufacturer (OEM) later discovered that the loss of clamping force, caused by the leakage through orifice, was not worth the extra cooling gain. For this reason the orifice is being phased out of production and will not be in new models. The TCC pistons in some foreign converters also had a similar orifice, but only in a limited number of applications. Today, the best approach for a rebuilder is to close the orifice with a small tig weld (Figure 2).



Another popular torque converter question is about the three .185" diameter holes (Figure 3) in the 300mm turbines.

Rebuilders often ask why they are found in the 300mm turbines and not in the 298mm turbines. To answer that question, you need to know how the lockup function differs between the two converters. In the 298mm converters, the turbine hub comes into contact with the conical washer which is in contact with the cover. In this type of converter, the TCC piston is free to move forward and backward for lockup apply and release, independently of the turbine hub. In the 300mm converter, the turbine hub is not held in a fixed position relative to the cover. In this type of converter, the small gaps at the end of the vanes provide a secondary path for balance oil (Figure 4). That path is not open in 300mm converters because their turbines are furnace brazed, which closes the holes (Figure 5). The three .185" holes provide the secondary oil path. Keep this in mind the next time you are using a furnace brazed turbine to build a performance converter. You may want to add a few holes to balance forward thrust.

The amount of oil needed to balance the thrust loads on the turbine seems to be fairly consistent. The three .185" holes in the 300mm turbine will pass about 26.8 GPM at 80 PSI at 180°F. The four .165" holes in the Allison 1000 converters will pass 28.4 GPM under the same conditions. A similar amount of oil was able to pass through the gaps at the end of the vanes on the 298mm turbines.

Don't miss Part 2 which covers the holes that allow oil to pass through the stators and turbine hubs.

Ed Lee is a Sonnax Technical Specialist who writes on issues of interest to torque converter rebuilders. Sonnax supports the Torque Converter Rebuilders Association.

Related Unit(s)
Subject(s) Included
  • General Diagnostics and Theory

While Sonnax makes every effort to ensure the accuracy of technical articles at time of publication, we assume no liability for inaccuracies or for information which may become outdated or obsolete over time.

Was this helpful? No

Thanks for your feedback! Contact Sonnax tech support for assistance.

Thanks for your feedback!