Transmission Parts Hyundai/Kia A6LF1/2/3 A6MF1/2 A6GF1 Valve Body Valve / Sleeve
Print Share View Instructions

Symptoms:

  • TCC codes
  • Converter shudder & failure
  • TCC slip
  • Low TCC apply pressure
  • Low TCC release pressure
  • Overheated fluid & TCC lining

Cause:

Wear at TCC pressure control plunger valve and sleeve assembly allows critical TCC switch oil to exhaust.

Correction:

Recover hydraulic control and renew TCC performance by installing drop-in Sonnax TCC pressure control plunger valve kit.

A6GF1, A6LF1/2/3, A6MF1/2

TCC Pressure Control Plunger Valve Kit
Part No. 102741-01K

You need this if... View Instructions Find a Distributor

The TCC pressure control plunger valve and sleeve assembly act to increase pressure to the TCC switch valve. When this control assembly wears, the oil driving the plunger valve and inboard control valve leaks to exhaust, resulting in decreased pressure to switch valve. This pressure deterioration can cause lockup apply issues, TCC codes and premature failure of the torque converter. Installation of Sonnax TCC pressure control plunger valve kit 102741-01K will arrest these leaks and reestablish appropriate TCC pressure control.

  • Sleeve is manufactured from highly wear-resistant aluminum
  • Hardcoat anodized aluminum valve combats premature wear
  • Restores proper hydraulic sealing and pressure control
  • Drop-in Zip Valve™ parts install quickly and easily
Learn More About Zip Valve™ Drop-In Repairs
  • Valve
  • Sleeve

Sonnax valve body layouts provide a detailed overview of individual units making it quick and easy to determine what’s available for the specific valve body you’re working on. See all Sonnax valve body layouts.

Hyundai/Kia A6GF1, A6LF1/2/3, A6MF1/2

Hyundai/Kia A6GF1, A6LF1/2/3, A6MF1/2
  • A6GF1, A6LF1/2/3, A6MF1/2 TCC Pressure Control Plunger Valve Kit 102741-01K
  • A6GF1, A6LF1/2/3, A6MF1/2 TCC Pressure Control Plunger Valve Kit 102741-01K

You need this if...

Excessive wear can often be visually identified by shiny patches on the inside diameter of sleeve. Wear can also be determined by vacuum testing, done through feed hole in OE sleeve. Using a small tip (available in Sonnax vacuum test stand kit VACTEST-01K) attached to the line, apply vacuum to one of the feed holes while covering the hole on the opposite side. Be certain OE plunger valve is installed in sleeve while checking.

If sleeve fails to hold at least 18 in-Hg, install this kit.

A6GF1, A6LF1/2/3, A6MF1/2 TCC Pressure Control Plunger Valve Kit Vacuum Test Locations
↑