Remanufactured Valve Body
Part No. CHR198

Find a Distributor

Save your existing manual valve for reuse with our remanufactured valve body.

  • 42RLE Remanufactured Valve Body CHR198

Chrysler 42RLE Valve Body Identification

Part Number Chart

Part Number
'93-'98 with Internal Round Pin MLPS Switch
CHR196 '98-Later with Internal Spade Pin MLPS Switch
CHR198 42RLE

Internal MLPS Switch Identification

Round Pin MLPS Switch Spade Pin MLPS Switch
CHR193 CHR196

VLP Identification

Beginning in 2007 with the Chrysler Sebring 2.4L and 2. 7L, this transmission has electronic line pressure control. Prior to this, the 604, 606 and 42RLE were fixed line pressure transmissions.

The transmission can be identified from the outside by an additional electrical connector sticking out of the case, next to the range sensor connector. It will either be 6 pins or 5 pins. Early connectors had 6 pins, with the #1 pin not being used. At some point, it was changed to a 5 pin configuration. Three wires go to the pressure sensor, and two wires go to the pressure solenoid. The TCM uses the pressure sensor as line pressure feedback to adjust line pressure to load conditions.

Pressure Sensor Connector Pressure Solenoid Connector
Pressure Sensor - Variable Force Solenoid Case Connector
  1. Empty
  2. 5v to Pressure Sensor
  3. Sensor Signal Return
  4. Sensor Ground
  5. 12v to Pressure Solenoid
  6. Pressure Solenoid Control

Pin #1 is missing; it was eliminated because it is not used.

The solenoid pack is still used with this valve body, just as it was with the non-variable line pressure units.