||'93-'98 with Internal Round Pin MLPS Switch|
|CHR196||'98-Later with Internal Spade Pin MLPS Switch|
|Round Pin MLPS Switch||Spade Pin MLPS Switch|
Beginning in 2007 with the Chrysler Sebring 2.4L and 2. 7L, this transmission has electronic line pressure control. Prior to this, the 604, 606 and 42RLE were fixed line pressure transmissions.
The transmission can be identified from the outside by an additional electrical connector sticking out of the case, next to the range sensor connector. It will either be 6 pins or 5 pins. Early connectors had 6 pins, with the #1 pin not being used. At some point, it was changed to a 5 pin configuration. Three wires go to the pressure sensor, and two wires go to the pressure solenoid. The TCM uses the pressure sensor as line pressure feedback to adjust line pressure to load conditions.
|Pressure Sensor Connector||Pressure Solenoid Connector|
|Pressure Sensor - Variable Force Solenoid Case Connector|
Pin #1 is missing; it was eliminated because it is not used.
While Sonnax makes every effort to ensure the accuracy of technical articles at time of publication, we assume no liability for inaccuracies or for information which may become outdated or obsolete over time.